microDRUM
http://microdrum.altervista.org/forum/

IDE installation and config tool
http://microdrum.altervista.org/forum/viewtopic.php?f=5&t=330
« Previous  Page 2 of 2
Author:  Sno0t [ 18/05/2017, 17:19 ]
Post subject:  Re: IDE installation and config tool

[Sorry for double post]
Author:  WesleyS [ 25/05/2017, 1:16 ]
Post subject:  Re: IDE installation and config tool

If you press Setup>>DrumMap you'll see this pop up. You can change what pin corresponds to what pad here to match the LCD. I'll have to think about your triggering problem before I give you an answer
https://www.dropbox.com/s/y9ftuftdbywwrzs/Screenshot%20%28238%29.png?dl=0
Author:  Sno0t [ 02/06/2017, 18:11 ]
Post subject:  Re: IDE installation and config tool

Hi Wes,
There are not enough words to thank for your help and your fast responses.
I Decided to Buy piezos and jacks as well as cables next month (and yes i mean july, currently my funds are....rather low) and start to combine everything to a 'prototype' drum to see where I could have done something wrong.
As soon as there is new development I will write back here.
I really want to geth this thing up and running to be finally able to play drums after 5 to 6 years of absence...

Kind regards,
Sno0t
Author:  WesleyS [ 08/06/2017, 17:06 ]
Post subject:  Re: IDE installation and config tool

Good luck! I'm gonna try to get the TeensyDRUM PCB's printed soon, I know I'm ready for this project to be complete too!
Page 2 of 2 All times are UTC + 1 hour