finally I had time beside the two small kids to start soldering the microdrum together
The board is beautiful, easy to work with, I'm already almost finished after two hours, but I still have some smaller questions which needs to be answered before I can finish assembling:
- I bought the parts using the parts list here: http://microdrum.altervista.org/forum/viewtopic.php?f=5&t=17
. In the Box&Jacks section it writes two resistors, one 1M and one 5k, for which I didn't find the place on the board. What are these for, and are these resistors necessary?
- On the board I can see a 3pin place marked "S". What is it for?
- I couldn't find any document about how the jacks should be wired to the 2x5 pin slots. Can someone send me an image about it?
- I decided to leave the whole MIDI part out because I'll connect the microdrum through USB. Is it enough if I don't solder these parts on the board, or should I do something else (set up something in the configuration, wire something together, etc)?